The part number is wh1x2727.
Tub in washing machine is loose.
The tub bearing is bad.
Check if the load of clothing is unevenly distributed.
4 possible reasons your washing machine makes banging noises 1.
Some top loaders have four rubber straps holding the tub to the four corners of the machine.
If that isn t the problem you can try the suspension rods.
All washing machines have a part called a tub bearing which the tub sits on allowing it.
The most common reason for a noisy washing machine is that.
If the washing machine is not balanced then it will shake violently during a spin cycle.
If it is wobbling with a normal load one of those springs or it s.
This is a major repair that requires considerable disassembly of the unit.
I noticed that the agitator which is attached in the middle of the machine is loose and floats u read more.
You should redistribute the load to solve this issue if the cause is due to too many clothes on a single side of the washer.
If one of these fails the tub goes out of balance.
The average washing machine spin speed is between 600 to 1400 rpm.
If that isn t the problem make sure the tub isn t loose and if you may have to tighten the hub nut as talked about on this thread.
This will cause water to spill on the floor.
The manufacturer recommends that if possible the complete outer tub and bearing be replaced rather than attempting to replace just the bearing in the tub.
Some front loading machines have ball bearings between the tub spindle and the motor shaft and if the casing wears and one or more of the bearings become dislodged the tub will vibrate.
Often they will break and can be causing your problem.
If the bearing is bad the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine.
Washing machine agitator loose easy fix if my advice has helped you.
For all your washing machine spare parts go to http bit ly 1dumbrv the most common fault in a washing machine drum is noise but there are several other pro.
