Dimming the led strip off when the led light strip is fully on press and hold for more than second the down button on the remote transmitter.
Sunsetter awning led lights not working.
If the remote control stops working with the awning it needs to be reset.
The set is cream colored to match your awning s hardware perfectly.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
Press and hold my for 8 seconds the light should blink the entire time.
Not available for the 1000xt model awning.
How to use the multi channel remote transmitter see figures 13 14.
Unplug the power cord from the wall.
If it does continue to the next step.
When a desired dimming level has been achieved release the down button.
If still not working you ll need to locate the power converter and make sure it s plugged into it s outlet.
On many rigs it s located behind the rear wall of the pass through basement storage.
There s a dedicated circuit breaker for the power converter.
You get a set of lights for each arm plus a waterproof transformer box that converts 110 volt to 12 volt to save energy.
Flip it off and back on and then recheck the test panel.
Test to see if this restored operation if not continue to the next step.
Unplug the motor and plug it back in.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
Be sure to order dimming led lights for your sunsetter awning.
The awning s motor or remote control is usually to blame when the unit stops working as you expect.
As you continue to hold the down button the led lights will dim down to fully off.
Control box the first time the led light system is plugged in.
You should always troubleshoot your awning before calling the manufacturer to see if you can solve the problem yourself.
Verify that the red light on the remote transmitter comes on when you press and hold the button.
Plug in the power cord and close the awning the rest of the way.
If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15.
Check power at the quick connect outlet or power source.
Press the neutral middle button on the transmitter.
The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit.
T z z á z u o u µ o o ç v z o µ o z á v v p o v p x.
If there is power present continue to the next step.
Control box the first time the led light system is plugged in.
If not replace the cr2430 battery.
